Quick Vision Touch Probe

This Quick Vision Touch Probe course is run over one day. It is advised that a minimum of six weeks are left between attending the Basic course and the Touch Probe course to allow for consolidation of prior learning.

The course is comprised of the following elements

  • Introduction to Touch Probe Technology
  • Calibration of Styli
  • Installation / Calibration of Probe Change Rack
  • 3D measurement using Probe and Lens

Get in touch!

For support, to place an order or to make enquiries please call:

01264 353123
8.30am till 5pm - Monday to Friday

 

Send a Message

FREE Education Pack

Mitutoyo's Education Pack comprises a range of items designed to serve as convenient references to the theory and practice of engineering metrology for use in the classroom, workplace and laboratory.

Claim your FREE pack

Our services

A complete solution - Mitutoyo is not only a vendor of top quality measuring products but one that also offers guaranteed support for the lifetime of the equipment, backed up by comprehensive services.

See our services

*Course length subject to variation depending on which route is taken